|
TO INSTALL YOUR WOOD FLOOR ANCHOR KIT FOR SPACE SAVER Start by using the Space Saver Instructions for locating your anchor points. Next place the floor plates with the Wood Floor Kit over the anchor points. The small plate with one stud goes next to the bar base and the larger plate with two studs is the outside of the installation rectangle. Mark clearly all the small holes in the floor plates. The small plates will “line up” with the angle of the Space Saver Arm to be bolted to them. The larger plates will be perpendicular to the Space Savers with both studs directly over the installation anchor points for the outside of the installation rectangle. Using a small drill bit (1/8”) pre drill all the holes in each plate before attempting to screw the 3/8” lag screws that came in the Kit. Using a standard socket type driver or a drill with a driver bit in it screw the lags into the floor securing the plates to the floor. Attached assembled Space Savers to these plates and proceed with the standing up of the bars as outlined in the Space Saver Installation information. GOOD LUCK Gym-Trix, Inc. |